What are the reasons why the incinerator can't work
There are many reasons for the incapability of incinerator combustion. Start to see whether the incinerator is locked, i.e. whether the reset button of the incinerator program controller lights up the red light (also known as the alarm light). If the light is not on, check whether the power supply of the incinerator is not input. If the power supply is normal, the alarm light is on, and press the reset button for 1 second to release
1. Is the wind pressure too small? Turn the wind pressure switch to very small
2. See if your flame detection UV is not enough to test the flame is not very ambitious
3. Whether the air supply pressure is consolidated and whether it reaches the incineration request
4. Insufficient flow, fuel or gas can not keep up
5. If there is a rugged pressure switch, consider the pressure question. Whether the self-test method has not been experienced
6. Is the combustion transformer normal We need to check one by one on the spot
The failure of the incinerator to operate the red light to put out the fire quickly led to the red light, which was the obstacle of the flame inspection system of the incinerator. The failure of the incinerator to fire but the program controller of the incinerator received the disturbing light signal that the flame once caused, mostly caused by the light leakage of the incinerator, the destruction of the photoelectric eye, the short circuit of the optical eye light line, etc;
Press the reset button for 1 second to release the air of the incinerator for flexible operation, but it is not found when the electric spark is found, and then the alarm is locked.
It is found that the electric spark is not injected or the injection is not foggy, and it is locked after a long time. Check whether the oil circuit switch is turned over and whether there is oil in the oil tank, whether the oil passes through the filter, whether the oil pump filter is blocked, whether the oil pipe leaks, whether the oil pump is damaged or worn, whether the coupling is damaged and slippery, whether the solenoid valve is obstructed and can not be turned over, and whether the oil nozzle is blocked, etc;
The injection can also spray flame, but then lock. This is that the program controller does not sense the flame. The photo eye may be damaged or the travel surface is dirty, the photo eye light line is open circuit, the program controller is damaged, the flame is not enough to consolidate, etc;
In a word, there are many reasons why the fuel oil incinerator doesn't ignite, and probably the reasons are intricate.
——Author：ebico