Due to the quality and safety doubt, natural gas incinerator is in the stage of continuous research and demand. Because natural gas is different from other fuel incinerators, once the natural gas incinerator leaks, it is completely different from the dangerous level of coal and oil incinerators. Therefore, when selecting and preparing natural gas incinerators, we should carefully select products of qualified brands to ensure personal safety.
Key points for failure of natural gas incinerator: air tightness, hot water production rate, electrical efficiency, flame consolidation, heat load and deviation, carbon monoxide content in flue gas, application efficiency, heat compliance, gas source identification, flameout guard assembly in normal organization, intake pipe standard and organization, etc.
The reason why the natural gas incinerator failed is that the gas company did not strictly check the installation process, and the factory inspection process was not conducted or was not careful; in order to reduce the cost, the incinerator manufacturing plant reduced the number of heat exchanger plates on the heat exchanger, resulting in high exhaust gas temperature, and the heat of high-temperature flue gas was not fully absorbed, so that the heat exchange of the water heater obeyed very low; incineration The incinerator with small heat load is used to replace the incinerator with large heat load in the incinerator manufacturing plant, so that the hot water yield, accuracy of heat load and heat compliance are all over negative deviation or do not meet the requirements; the heat load of the water heater is not matched with the organization of the incinerator, the space required for incineration is not enough, and the standard of the ejector pipe of the incinerator is too small to ensure sufficient primary atmosphere coefficient or normal incineration Burning, or burning worsens when the flue is blocked, the carbon monoxide in the flue gas rises sharply; the company has a deviation in the standard inquiry, and the grounding terminal is connected to the air valve or water valve, and the compression facilities are not adopted, so the grounding facilities are extremely unreliable; the selected link component - air pressure switch is always on, so it can not be used to cut off the electrical circuit due to excessive air pressure.
In order to avoid the quality doubt of the natural gas incinerator, the related quality supervision bureau shall, according to the related regulations, conduct rectification within a time limit and purchase the unqualified incinerator. The company whose commodity quantity is serious and does not meet the requirements of the standard has taken care of the relevant Municipal Quality Supervision Bureau and filed for investigation according to the law. The related experts shall be invited to give lectures to the company's quality sellers As required by the standard, it helps the unqualified commodity production company to find out the question, explain the notice of the unqualified commodity, set up the rectification facilities and urge the company to implement them; for the commodity production with regional quality doubt, it intensively exposes the quality warning and opens up the special rectification.
Ebico is a famous incinerator manufacturer and exporter. In order to ensure the quality of incinerator, we use industrial materials that meet the required technical level to make our products. If you are screening a natural gas incinerator, I believe that the best choice for you is to choose ebito!
——Author：ebico